In this report we’re going to look at how to make your own dog mask. We’ll cover the basics and then go on to take a look at some of the more advanced tips and tricks which you can use.
For those who have a dog that likes to bark, and particularly if your dog loves to play in the backyard and other regions of the house, you need to get them some particular dog protection.
Paper Plate 3d Dog Mask DIY Materials: This is the initial part of the set-up that will look a little scary at first, but it’s actually quite straightforward. All you have to do is take a cardboard cutting board and cut the cardboard into the shape of your mask. You can’t just cut a rectangular shape out of the cardboard, so you will need to cut around the edge of the mask so you get something that resembles a cone. The most important thing here is to be realistic with what type of paper plate that you’re using.
Then you’ll need to wrap the cardboard around the edges of the paper plate, making certain there is a good seal between the two pieces so you can ensure that nothing will leak once you place the mask on. Be sure that the edges are cut so that the edges are not sharp, as this may damage the edges of the mask.
Glue it on! The next step involves using some paint. You should spray the paint over the cardboard, making sure that it runs smoothly and evenly across the entire mask. You’ll want to start with one side of the mask , so you can work your way around it before moving onto the other side. The paint needs to be slightly thicker than the cardboard, and it is best that you leave about one-fifth of an inch of paint on the edges so that it runs over the cardboard.
Don’t worry too much about the paint getting stuck to your mask. It’s easy to remove it later, and it’ll leave you with a wonderful finished mask to show off to everybody! It’s also a good idea to wipe away any excess paint after you are done, so you don’t end up with smudges or smears on your dog.
Then it’s time to glue the mask onto your dog’s head. First you need to make sure that you have a secure fit between the mask and your dog’s head. Once you’ve made sure that it is secure, then you can start to glue the mask on the dog’s face. Take the piece of cardboard that’s used for the base of the mask and fold it over. Be certain it’s quite powerful and then use your hands to ensure the cardboard down in place.
Keep your hands out of the way and use tape to hold it in place as you repeat the procedure on the cardboard folds until you have the mask snugged firmly onto the surface of your dog. Don’t make the folds too large or else it might look messy. Once you’ve done this, you can then take out the mask and attach the cardboard ears. And attach the other area of the mask on the dog. Make certain the ears are flat and indoor dog cages be certain it is not too short or long as this will cause some problems with the mask slipping off the dog’s face.
If you’re using a dog mask as your dog protection, you’ll have to do some sanding to be sure that it is secure on your dog. You can do it by sanding off any excess paper that may have been removed from your mask.